Congratulations to BLCH Pneumatic Technology Co., LTD. On May 27, 2017, the electric proportional valve ITV2050 series p
Working environmentThe design of pneumatic fittings should allow the free flow of required air or gas without any oppor
Description of filter working principle:The compressed air from the inlet is strongly rotated through the tangential gap
Dear friends and customers :we come back to work from holiday. We thank everyone for your support and trust in the pa
Cylinder AccessoriesEven when a cylinder is sized properly, it may stroke too fast and require use of a flow control, ty
In 2004, due to the persistence of the pneumatic industry, we established BLCH Pneumatic & Technology Co., Ltd. Suddenly
A latching relay is a type of relay that can maintain its position without being continuously energized, which makes it useful in applications where power consumption needs to be minimized. It uses a magnetic mechanism to "latch" into position and hold that position until a new signal is received. This is typically accomplished by using two coils that operate in opposite directions, with one coil used to set the position of the relay and the other used to reset it. When the set coil is energized
The overall cost to replace the shift solenoid in an automatic transmission ranges from $200 to $500 for a single solenoid. If the damage requires you to replace the entire solenoid pack the cost increases to between $250 and $700
Solenoid valves are used wherever fluid flow has to be controlled automatically. They are being used to an increasing degree in the most varied types of plants and equipment. The variety of different designs which are available enables a valve to be selected to specifically suit the application in question.
How do you reset a solenoid valve? On regular solenoid valves, it can be switched back to the operating position by energizing the solenoid, while on solenoid valves with latch-lock function it will not be so. After being energized, the valve must be manually reset by pushing the reset-knob
One of the important parts of the pneumatic components is the cylinder. In order to ensure the normal use of the cylinder and avoid unnecessary situations, for the use of the pneumatic components and cylinder, let’s check the right way to use cylinder. When using the cylinder, the air quality requirements are very high. Clean, dry compressed air should be used. The air should not contain organic solvents, synthetic oils, salts, corrosive gases, etc., in order to avoid bottle and valve failure.
A solenoid is a device comprised of a coil of wire, the housing and a moveable plunger (armature). When an electrical current is introduced, a magnetic field forms around the coil which draws the plunger in. More simply, a solenoid converts electrical energy into mechanical work.
