Working environmentThe design of pneumatic fittings should allow the free flow of required air or gas without any oppor
Pneumatic transmission and control technology, referred to as pneumatic, is the compressed air as the working medium to
Advantages of pneumatic components: 1. Pneumatic device is simple in structure, light and easy to install and maintain.
CONGLATULATION!The "Internal Pilot Guide of the Precision Pressure Reducing Valve" standard which was lead drafted by o
Sensors are a means of providing feedback to a control system, so that the operating parameters of an application can be
Warm congratulations to BLCH Pneumatic, for the success of 350kWp distributed photovoltaic power generation project test
The solenoid valve should be installed with the inlet port (usually marked as port 1) connected to the upstream flow and the outlet port (usually marked as port 2) connected to downstream. Some solenoid valves will also be marked with an arrow on the body indicating the direction the media should flow.
How do you reset a solenoid valve? On regular solenoid valves, it can be switched back to the operating position by energizing the solenoid, while on solenoid valves with latch-lock function it will not be so. After being energized, the valve must be manually reset by pushing the reset-knob
A proportional control valve is a valve used to control fluid flow rate by varying the size of the flow passage via a restrictor. The regulated flow rate subsequently adjusts parameters affecting a process in a system, mainly level, pressure and temperature.
Rusting, power failure, irregular pressure, missing equipment, an incorrect amount of voltage or current, dirt stuck in the system and corrosion are some of the possible reasons why a solenoid valve may not properly close or open.
It works on the principle of electromagnetism. The electromagnetic field that creates the temporary magnetic field is energised when the relay's circuit detects the fault current. This magnetic field moves the relay armature to open or close connections.
One of the important parts of the pneumatic components is the cylinder. In order to ensure the normal use of the cylinder and avoid unnecessary situations, for the use of the pneumatic components and cylinder, let’s check the right way to use cylinder. When using the cylinder, the air quality requirements are very high. Clean, dry compressed air should be used. The air should not contain organic solvents, synthetic oils, salts, corrosive gases, etc., in order to avoid bottle and valve failure.
